INSTALLATION
4
Recommendations
IMPORTANT: Disconnect
the
oven from
the
mains before. carrying
out
any installation work
or
servicing.
• Installation must be carried
out
by a qualified technician
in
accordance
with
the manufacturer's
instructions and
in
compliance
with
local regulations.
• Unpack
the
oven.and make sure that the oven
has
not
been damaged during transport
and
that the
oven
door
closes properly.
If
you are not sure contact
the
dealer
or
the
nearest service centre.
•
After
removing the oven from its packaging, leave
it
on the polystyrene
base
to
prevent
it
from being
damaged.
• When installing
the
oven
it
is
advisable
to
wear
protective gloves.
• The oven
is
provided
with
two
side handles
proDD
(B)
to
facilitate installation (fig. 7).
Preparing
the
housing unit
• Kitchen units in contact
with
the oven must be heat resistant (80°C min).
•
Cut
the
kitchen unit and
worktop
to
fit
before installing
the
oven. Carefully remove any
shavings
or
sawdust that could prevent
the
oven
from
running properly.
• The dimensions
ofthe
housing units in which the oven
can
be installed are shown in figures
I,
2
and
3.
The dimensions
of
the oven are shown in figure
4.
•
To
allow
for
proper
ventilation,
an
opening should be left at
the
bottom
of
the
housing unit.
Pay
attention
to
the
dimensions.
The
bottom
of
the
oven must
not
be
accessible after installation.
• During installation make sure that the sides
of
the oven
do
not
touch the adjacent units.
3
To Next Page
Loading...
Need help?
General
