Need help?Do you have a question about the Primare A30.1 and is the answer not in the manual?
General| Input Sensitivity | 1.2 V |
|---|---|
| Signal-to-Noise Ratio | > 100 dB |
| Damping Factor | > 100 |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion | < 0.1% |
| Dimensions | 430 x 100 x 350 mm |
| THD + N | < 0.1% |
Details the amplifier's 100 Watts per channel power output for quality sound.
Describes the six sound source inputs and the optional RIAA amplifier.
Explains balanced outputs for signal integrity and variable outputs controlled by volume.
Highlights the simple and intuitive front panel controls for the A30.1.
Discusses using the A30.1 with other Primare products for a fully integrated system.
Details amplifier power output into different loads and speaker terminal impedance.
Lists input impedance, sensitivity for various inputs, and frequency response.
Specifies signal-to-noise ratio and maximum power consumption details.
Provides the physical dimensions and weight of the unit.
Explains the function of each front panel control.
Explains how to switch the amplifier on and put it into standby mode.
Describes how to select an audio input source using the front panel or remote.
Details how to adjust the volume level and sound balance between channels.
Describes how to change the phase from 0° to 180° for optimal sound reproduction.
Explains how to make recordings using the amplifier's tape outputs and monitor function.
Identifies and describes the various connection ports on the back panel of the amplifier.
Provides instructions and warnings for connecting the amplifier to the mains power supply.
Explains the loudspeaker and preamplifier outputs and their connections.
Details how to connect various sound sources to the amplifier's inputs.
To Next Page
