<
Using the I20 Integrated Amplifier
5
SELECTING A SOURCE
The I20 Integrated Amplifier provides a choice of four line inputs, labelled:
CD, TUNER, LINE 1, and LINE 2.
To select a source
• Press the button on the front panel or the remote control corresponding to
the source you want to select.
The currently selected source is indicated by a V on the front panel display:
For example:
23
V
• Alternatively, press the A or V buttons on the remote control to step
between sources.
CHANGING THE VOLUME
The I20 allows you to vary the volume from 0 (silence) to 79 (maximum
volume).
To change the volume
• Rotate the VOLUME control on the front panel, or press the < or > buttons
on the remote control.
The current volume setting is shown on the front panel.
For example:
24
V
CHANGING THE BALANCE
You can change the balance of the sound between the left and right channels
to shift the position of the stereo image.
To change the balance
• Press the [/BAL button on the remote control.
The front panel display shows the current balance setting, where -6
corresponds to the leftmost position, 0 corresponds to centre, and 6
corresponds to the rightmost position.
For example:
-2
V
• Press the < or > buttons on the remote control to adjust the balance.
•Press the [/BAL button again to revert to the normal volume display.
Alternatively the normal display will revert automatically after four seconds.
§2 Using 19/6/02, 10:16 am5
To Next Page
Loading...
