Bravo II Calibration Instructions (For use with Bravo 2 Utility)
A. Installing the Utility
1. Double click on the file downloaded from the website. A setup program will launch.
2. Follow through the setup, click next at each step to accept defaults for file installation.
(Recommended)
3. After installing this program, the folder it created with program listed should automatically
open. You will need to click on the program name Bravo 2 Firmware Updater to run the
software. If the folder does not automatically open after installation, then you will need to open
the program by clicking on the 'Start' button, then go up to the Programs menu, next go to the
Production Tool Group, then select Bravo 2 Firmware Updater.
B. Using the Utility
Once the program opens, click the 'GET STATUS' button. You should see information related
your Bravo appear in the window below
To Next Page
