What to do if the overlaminate film is not adhering properly to my Primera Laminator discs?
If the overlaminate film isn't sticking to the disc label, try increasing the heat setting. Use the Heat Slide Bar on the Laminator's Control Panel to slide the Heat Setting one or two hash marks toward the front of the Laminator.
Why is the overlaminate film wrinkling on my Primera Laminator?
If the overlaminate film is wrinkling and has scratch-like marks on the disc surface, try decreasing the heat setting. Adjust the Heat Slide Bar on the Laminator's Control Panel, sliding the Heat Setting one or two hash marks toward the rear of the Laminator.
How to find the laminate option in PrimoDVD for Primera Laminator?
In PrimoDVD, access the Laminate checkbox by clicking 'Robotics' then 'Options'. If this option is missing, install the software from the provided disc, which includes an updater to add this functionality.
General| Category | Disc Duplicator |
|---|---|
| Disc Capacity | Up to 100 Discs |
| Manufacturer | Primera |
| Supported Disc Types | CD, DVD, Blu-ray |
| Operating System Compatibility | Windows, Mac OS X |
Connect the FireWire cable from the Duplicator to your PC's FireWire board output port.
Perform a hardware test by powering up the PC and Duplicator, placing discs, and using buttons to test robotic arm movement and disc handling.
Install the printer driver software and the PrimoDVD 2.0 application software on your PC according to the provided instructions.
Launch PrimoDVD 2.0 and specify the locations of the drives in the Optical Disc Duplicator MAX using the dialog box.
Test the entire hardware/software configuration to confirm that all components are communicating properly.
Step-by-step guide to perform a simple audio CD copy job using the PrimoDVD software, including creating a disc image.
To Next Page
