EasyManuals Logo

Primera Bravo Pro Operator's Manual

Primera Bravo Pro
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SECTION I: SETUP
1. Check to make sure the following items are enclosed:
Output Bin Holder
Output Bin
Operators Manual
and other information
2. Attaching the Output Bin
Attach the Output Bin
Holder as shown,
aligning the Locating
Tabs on the Output
Bin Holder with the
Slots located on the
underside of the
Publisher allowing
the holder to hang off
the edge of the table.
Notice the slots do
allow for adjusting the
position of the output
bin. If your discs are
not falling into the
bin, you will be able to
move the bin slightly
to align it.
Place the Output Bin on
the Output Bin Holder
as shown.
SECTION II: ENABLING KIOSK MODE
To enable Kiosk mode refer to the following sections in the manual:
- Section 3E for PC
- Section 4 for the MAC
Thank you for purchasing the Kiosk Kit for the Disc Publisher Pro . (Referred to hereafter as the "Publisher"). This will enable your Publisher to
use both the right and left bins as input, doubling the capacity of your Publisher. This sheet describes the installation and use of the Kiosk Kit.
Slots
Locating Tabs
Output Bin Holder
Output Bin

Other manuals for Primera Bravo Pro

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Primera Bravo Pro and is the answer not in the manual?

Primera Bravo Pro Specifications

General IconGeneral
BrandPrimera
ModelBravo Pro
CategoryDisc Duplicator
LanguageEnglish

Related product manuals