83
Chapter 7
Troubleshooting
Do not attach or remove any cables while the camera system is powered on.
Introduction
The following issues have corresponding troubleshooting sections in this chapter.
Acquisition Started but Viewer Contents Do Not Update
Baseline Signal Suddenly Changes
Camera1 (or similar name) in Camera Name field
Controller Is Not Responding
CoolCUBE
II
: Low Coolant (Air in the Hoses)
Data Loss or Serial Violation
Data Overrun Due to Hardware Conflict message
Data Overrun Has Occurred Message
Error Creating Controller message
Overexposed or Smeared Images
Serial violations have occurred. Check interface cable.
To Next Page
Loading...