Epson FX Emulation
Page 3-16
Vertical Position
Line Feed LF
Causes the current line to be printed, and then advances the paper one line at the
current line spacing. If "Auto CR: On" is selected in the "Setup: INTERFACE"
menu, a carriage return will also be performed.
Control code: LF
Hexadecimal: 0A
Variable Distance Line Feed ESC J n
Causes the current line to be printed, and then performs a single line feed of n/216ths
of an inch. 0≥n≥255. Does not change the current line spacing. If "Auto CR: On" is
selected in the "Setup: INTERFACE" menu, a carriage return will also be performed.
Example: The following escape sequence will advance the paper one half inch.
Escape Sequence: ESC J 108
Hexadecimal: 1B 4A 6C
Variable Distance Reverse Line Feed ESC j n
Performs a single reverse line feed of n/216ths of an inch. 0≥n≥255. Does not
change the current line spacing. If "Auto CR: On" is selected in the "Setup:
INTERFACE" menu, a carriage return will also be performed.
Example: The following escape sequence will move the paper down one half inch.
Escape Sequence: ESC j 108
Hexadecimal: 1B 6A 6C
To Next Page
Loading...
