IBM Proprinter Emulation
Page 4-7
Character Attributes
Select Emphasized Mode ESC E
Selects emphasized mode. This makes characters bolder by printing an extra dot to
the right of each dot normally found in the character matrix. This will cut the print
speed in half, but will not require an additional pass of the print head. Overrides the
"Impact:" value in the "Setup: FORM" menu.
Escape Sequence: ESC E
Hexadecimal: 1B 45
Cancel Emphasized Mode ESC F
Cancels emphasized mode. Overrides the "Impact:" value in the "Setup: FORM"
menu.
Escape Sequence: ESC F
Hexadecimal: 1B 46
Select Double-Strike Mode ESC G
Selects double-strike mode. This makes text bolder by printing it twice. This will cut
the print speed in half, because an additional pass of the print head will be required.
Escape Sequence: ESC G
Hexadecimal: 1B 47
Cancel Double-Strike Mode ESC H
Cancels double-strike mode.
Escape Sequence: ESC H
Hexadecimal: 1B 48
Underline Mode ESC - n
Selects underline mode for n=1, or cancels for n=0. This mode provides continuous
underlining for all characters, including spaces.
Example: The following escape sequence will turn underlining on.
Escape Sequence: ESC - 1
Hexadecimal: 1B 2D 31
To Next Page
Loading...
