IBM Proprinter Emulation
Page 4-10
Set Line Spacing to n/216" ESC 3 n
Sets the line spacing to n/216 of an inch per line. 0≥n≥255. Overrides the "LPI:"
value in the "Setup: FORM" menu.
NOTE: The actual resolution of the FormsPro 4000 paper stepper motor is 1/288 of
an inch. When spacing is specified in 1/216 of an inch, the printer will actually move
paper to the nearest 1/288 of an inch.
Example: The following escape sequence will set line spacing to one half inch.
Escape Sequence: ESC 3 108
Hexadecimal: 1B 33 6C
Set Line Spacing to n/72" ESC A n
Sets the line spacing to n/72 of an inch per line. 0≥n≥255. Since the distance
between print head wires is 1/72 of an inch, this is equivalent to setting n wire
spacing. This spacing is stored but does not take effect until ESC 2 is received.
Overrides the "LPI:" value in the "Setup: FORM" menu.
Example: The following escape sequence will set line spacing to 8/72 of an inch, for
use with eight wire graphics.
Escape Sequence: ESC A 8
Hexadecimal: 1B 41 08
To Next Page
Loading...
