5
1.1- “CE” MARKING
The “CE” marking consists of a gray lable applied on the back of the oven.
The plate bears in readable and indelible way the following data:
- Name of the manufacturer; - Serial number ;
- CE marking; - Electric voltage and frequency (Volt/Hz);
- Model (MOD); - Year of construction ;
-Electric power (kW/A); - Weight of the oven;
- “Made in Italy”
2—GENERAL INFORMATION
2.1- THE IMPORTANCE OF THE MANUAL
Before using the concerned oven, it is compulsory to read and understand this manual in all its
parts.
This manual is an integral part of the oven and must be preserved until its final dismantling.
The manufacturer declines all liability for eventual dmages to persons, animals, and things caused
by the inobservance of the regulations described in this manual.
This manual must always be available for the “authorized oeperators” and has to be placed and pre-
served colse to the oven.
The “authorized operators” must perform on the oven exclusively interventions for which they are
specifically competent.
1—DECLARATION OF CONFORMITY AND MARKING
2.2– STATUS OF “TURNED OFF OVEN”
Before performing any type of maintenance and/or adjustment intervention, it is compulsory to dis-
connect the power supply source, disconnecting the power supply plug from the mains outlet verify-
ing that the oven is effectively turned off and cooled.
2.3– WARRANTY
The manufacturer warrants that the concerned ovens are tested at manufacturer’s premises.
The warranty of the oven is of 12 (twelve) months.
THE TAMPERING AND/OR REPLACEMENT OF PARTS WITH NON ORIGINAL
SPARE PARTS CAUSE THE DECAY OF THE WARRANTY AND RELEASE THE MANU-
FACTURER FROM ANY LIABILITY.
To Next Page
Loading...