57289
REVISED
2.1.06
10
NOTE:
⇒ Measure from center of eccentric
adjustment bolt to ground to ensure
proper height.
⇒ On alignment, both sides inner and
outer tie rods may need to be pulled
out of adjusting sleeve and cut 1/2” off
tie rod ends so proper adjustment can
be achieved.
⇒ After installation is complete, dou-
ble check that all nuts and bolts are
tight. (Do not retighten nuts and bolts
where loctite was used). Recheck pe-
riodically.
ILLUSTRATION 11
PASSENGER SIDE
FLAT
WASHER,
1/2”
NYLOC
NUT, 1/2”
COMPRESSION STRUT
90-2155 (PASS.)
90-2154 (DRVR).
SLEEVE
90-2109
BUSHING
15-11148
HEX BOLT,
1/2” X 4” LG.
F
R
O
N
T
O
F
V
E
H
I
C
L
E
A-ARM
DROP
BRACKET
To Next Page
Loading...