57289
REVISED
2.1.06
3
90-4009 Spindle Adapter - Drvr. 1 8
90-4010 Spindle Adapter - Pass. 1 8
Box 2 of 2-PN 57289-2
Part # Description Qty. Illus. Page
ONE OF THE FOLLOWING REAR KITS WILL BE USED IN CONJUNCTION WITH THIS BASE KIT:
57589 ‘86-’89 4-Runner with 2.5” Rear U-Bolts
‘86-’95 Pickup w/ 2.5” Rear U-Bolts
95-350 3 1/2” Rear tapered Blocks (9/16”) 2 14
13-90126 9/16” U-bolts (2-1/2” Wide) 4 14
13-10423-Z 9/16” U-bolt Nut 8 14
13-30330-Z 9/16” U-bolts Washers 8 14
-OR-
57789 ‘86-’89 4-Runner with 3.25” Rear U-Bolts
‘86-’95 Pickup w/ 3.25” Rear U-Bolts
20-830671-2 3 1/2” Rear Tapered Blocks (7/8” Pin)2 14
13-90321 9/16” U-bolts (3.25” Wide) 4 14
13-10423-Z 9/16” U-bolt Nut 8 14
13-30330-Z 9/16” U-bolt Washers 8 14
-OR-
57489 ‘90-’95 4-Runner
90-1204 Lower Link Relocating Bracket 2
90-1272 Upper Link Relocating Bracket 2
90-2130 Bump Stop Extension 2
90-1268 Trac Bar Relocating Bracket 1
90-2133 Sway Bar Extension 2
90-7210E Brake Hose 1
5242-1 Limiting Strap 2
THE FOLLOWING PARTS ARE USED IN CONJUNCTION WITH THIS KIT, AND MUST BE OR-
DERED SEPARATELY.
318514 ES3000 SHOCKS (FRONT) 2
326506 ES3000 SHOCKS (REAR) 2
‘86-’89 4-RUNNER
‘86-’95 PICKUP
-OR-
326513 ES3000 SHOCKS (REAR)
‘90-’95 4-RUNNER
PLEASE NOTE: ON SOME V6 MODELS, A HIGH MISALIGNMENT
DRIVESHAFT MAY BE REQUIRED IF THE ORIGINAL EQUIPMENT DRIVE-
SHAFT BINDS AT THE CONSTANT VELOCITY JOINT AFTER THE LIFT KIT
IS INSTALLED.
To Next Page
Loading...