Pro-face GP-4301T Replacement Guidebook

27/44
NOTE
・ The “Hardware Installation” dialog box as shown below may appear during
installing the USB driver depending on the security level of Windows® XP.
Click [Continue Anyway] to start installing the driver. When installation is
completed, click [Finish].
・ If the following symptoms appear on Microsoft Windows® 7, go to updating
“USB Data Transfer Driver” on [OtasukePro!] for download
(http://www.pro-face.com/otasuke/download/update/proex/proex/v260/g
pproex_usb_transfer.htm).
- An error occurs when GP-Pro EX or Transfer Tool is installed
- An error occurs when data is transferred via a USB transfer cable
(model: CA3-USBCB-01).
(2) Trun on the power of GP-4501T/TW. The “Initial Start Mode” screen will appear on
the display unit. After transferring a project file once, this screen will not appear
again.

Pro-face GP-4301T Specifications

General

Brand	Pro-face
Model	GP-4301T
Category	Touch Panel
Language	English