How to turn on Pro-Form Treadmill?
If your Pro-Form Treadmill isn't turning on, ensure the power cord is plugged into a properly earthed outlet and the key is inserted into the console. Also, check the power switch. If the switch protrudes, it may have tripped. Wait five minutes, then press the switch back in to reset it.
What to do if Pro-Form Treadmill turns off during use?
If your Pro-Form Treadmill shuts off while you're using it, check the power switch first. Make sure the power cord is securely plugged in. If it is, unplug it, wait five minutes, and then plug it back in. Also, try removing and reinserting the key from the console.
Why is the walking belt slipping on my Pro-Form Treadmill?
If the walking belt on your Pro-Form Treadmill slips when you walk on it, first remove the key and unplug the power cord. Then, using the hex key, turn both idler roller screws clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform.
How to fix a Pro-Form Treadmill walking belt that slows down when walking?
If the walking belt on your Pro-Form Treadmill slows down when you walk on it: * Remove the key and unplug the power cord. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform. * Also, make sure that the gap between the Magnet and the Reed Switch is about 1/8 inch. If necessary, loosen the screw, move the Reed Switch slightly, and then retighten the screw.
How do I recalibrate the incline on my Pro-Form Treadmill?
To recalibrate the incline system on your Pro-Form Treadmill, enter the settings mode. Press the Stop button once, and then press the Incline increase or decrease button. The treadmill will automatically rise to the maximum incline level and then return to the minimum level.
What to do if Pro-Form Treadmill walking belt is not centered?
If the walking belt on your Pro-Form Treadmill is not centered and rubs against the foot rails, it may become damaged. First, remove the key and unplug the power cord. If the walking belt has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller screw counterclockwise 1/2 of a turn.
How to turn off demo mode on Pro-Form Treadmill?
If the console displays on your Pro-Form Treadmill remain lit after removing the key, it's likely in display demo mode. To turn off the demo mode, hold down the Stop button for a few seconds.
Instructions for connecting the treadmill's power cord to an outlet.
Steps for safely folding the treadmill into its upright storage position.
Instructions for moving the folded treadmill using its wheels and handrails.
Procedure for unfolding the treadmill from storage to its operational position.
Routine cleaning and inspection procedures for the treadmill.
Solutions for common treadmill problems like power issues or incline faults.
Guidance on setting exercise intensity based on heart rate zones.
Recommendations for warming up, training, and cooling down during workouts.
Advice on how often to exercise for maintaining or improving fitness.
General| Model Number | PETL49817.0 |
|---|---|
| iFit | Yes |
| Heart Rate Monitoring | EKG Grip Pulse Sensor |
| Folding | Yes |
| Cushioning | ProShox Cushioning |
To Next Page