Why does my pro.point 8836363 Power Tool lose power under load?
If your pro.point Power Tool runs at normal speed but loses power under load, this may be due to worn motor parts. It is recommended to have a qualified technician service the tool or replace the tool or its parts.
What to do if the press efficiency drops on my pro.point Power Tool?
If the press efficiency drops, it might be due to low hydraulic oil. In this case, you should purge air from the hydraulic system as described under Operation—Before First Use.
Why is my pro.point 8836363 Power Tool running slowly?
If your pro.point Power Tool runs slowly and air flows slightly from the exhaust, the air regulator might be in a closed position, or there could be damage or excessive wear on internal parts. First, open the air regulator to the desired airflow. If the issue persists, have a qualified technician service the tool or replace the tool or its parts.
How to fix a slow running pro.point 8836363?
If your pro.point Power Tool runs slowly and air flows slightly from the exhaust, the motor parts may be jammed with dirt particles, or the airflow may be blocked by dirt. Check the air inlet filter for blockage. Pour air tool lubricating oil into the air inlet as per the lubrication instructions to clear shipping grease. Operate the tool in short bursts to clear debris. If the tool is still jammed, clean it and lubricate it per the lubrication instructions.
General| Brand | pro.point |
|---|---|
| Model | 8836363 |
| Category | Power Tool |
| Language | English |
Mandates wearing CSA or ANSI approved personal protective equipment.
Details required PPE like safety goggles, face shields, gloves, and protective clothing.
Advises against operating while tired/impaired, wearing loose clothing, or overreaching.
Warns against complacency and emphasizes adhering to safety rules for preventing serious injury.
Warns about hydraulic fluid penetration, load capacity, and hot oil.
Highlights severe risks of fluid injection and preventative measures.
Addresses power loss, slow operation, and efficiency drops with possible causes and fixes.
To Next Page
