pro.point 8836363 - Troubleshooting; Common Issues and Solutions

8836363 40-TON HYDRAULIC SHOP PRESS V1.0
16 For technical questions call 1-800-665-8685
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does
not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
PROBLEM(S)
POSSIBLE CAUSE(S)
SUGGESTED SOLUTION(S)
Tool runs at
normal speed,
but loses
power under
load.
Motor parts worn.
1. Have a qualified
technician service the
tool.
2. Replace tool or parts.
Tool runs
slowly. Air
flows slightly
from exhaust.
Motor parts jammed
with dirt particles.
OR
Airflow blocked by
dirt.
1. Check air inlet filter for
blockage.
2. Pour air tool lubricating
oil into air inlet as per
lubrication instructions for
clearing shipping grease.
3. Operate tool in short
bursts to clear debris.
4. If tool still jammed, clean
tool and lubricate per
lubrication instructions.
Tool runs
slowly. Air
flows slightly
from exhaust.
1. Air regulator in
closed position.
2. Damage or
excessive wearing
of internal parts.
1. Open the air regulator to
desired airflow.
2a. Have a qualified
technician service the
tool.
2b. Replace tool or parts.
Press
efficiency
drops.
Low hydraulic oil.
Purge air from hydraulic
system as described under
Operation—Before First Use.