CONNECT THE BATTERY
NOTICE! Do not reverse the polarity when connecting the
battery as as this will short circuit the battery charging
system or damage the equipment
The engine has an electric start option that requires a 12 volt battery
(sold-separately). Use a 12V DC battery with a rating of at least 18
ampere-hours with the engine.
Battery cables are not included unless listed in the Unpacking Contents
section.
The polarity of each battery cable is displayed on a rubber cover where
they connect on either side of the starter motor.
1. Remove the wing nuts from the battery’s positive (+) and negative
terminals (-).
2. Slide the positive battery cable lug onto the positive terminal. Coat
the cable end with grease and reattach the wing nut. Tighten hand-
tight.
3. Slide the negative battery cable lug onto the negative terminal.
Coat the cable end with grease and reattach the wing nut. Tighten
hand-tight.
4. Secure the battery so it won’t move while the engine is in use.
OPERATIONS
NOTICE! The engine is not shipped with oil. Before starting
the engine, add oil according to the instructions in this
manual. Starting the engine without oil will damage the
engine beyond repair.
Check the engine’s condition before operating to maximize the user’s
safety and the service life of the engine. Ensure that the engine is level
and the switch is in the OFF position before beginning the pre-
operation checks.
8953101
4,650W GASOLINE GENERATOR WITH ELECTRIC START V1.0
Assistance available at www.princessauto.com or 1-800-665-8685 Page 8
To Next Page
Loading...
