EasyManua.ls Logo

pro.point 8953101 - Page 64

pro.point 8953101
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STORING THE ENGINE WITH FUEL
WARNING! Keep the engine away from ignition sources
such as sparks, the open flame of a pilot light when storing
with fuel in the tank. An ignition source can ignite gasoline
vapours.
1. If your engine will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapour
ignition.
a. Select a well-ventilated storage area away from any appliance
that operates with a flame, such as a furnace, water heater, or
clothes dryer.
b. Avoid any area with a spark-producing electric motor.
c. Avoid any area where power tools are operated.
2. If possible, avoid storage areas with high humidity, as this
promotes rust and corrosion.
3. Keep the engine level in storage. Tilting can cause fuel or oil
leakage.
4. Cover the engine once the engine and exhaust system is cool.
Some materials can ignite or melt if the engine and/or exhaust
system is hot. Do not use sheet plastic as a dust cover.
Use a cover made from a breathable fabric to prevent rust and
corrosion.
5. Store with gasoline that does not contain ethanol or a similar
alcohol-based fuel additive. Fuel with alcohol-based additives may
phase separate into gasoline, alcohol and water when stored for
more than a few weeks.
REMOVAL FROM STORAGE
1. Check the engine as described in the section Pre-Operation
Checks.
2. If the fuel was drained during storage preparation, fill the tank with
fresh gasoline.
3. If the cylinder was coated with oil during storage preparation, the
engine will smoke briefly at start up. This is normal.
V1.0
GÉNÉRATRICE À ESSENCE AVEC DÉMARRAGE ÉLECTRIQUE, 4 650 W 8953101
Page 15 Assistance available at www.princessauto.com or 1-800-665-8685

Related product manuals