11
2） Screw the fastening screws of the meter battery cover and move away.
3） Replace the old battery.
4） Install the battery cover as previous.
Note:
Do not violate the battery polarity.
5.2 Replace Test lead
Warnings
When replacing the test lead, the new ones shall be of the same or in equal
level. The test lead shall be in good condition, test lead level: 1000V 10A.
If the insulation layer of the test lead is damaged, such as the metal wire of the cable is
exposed, then it shall be replaced.
6. Accessories
To Next Page
Loading...
