Need help?Do you have a question about the Pro's Kit MT-3209 and is the answer not in the manual?
General| Model | MT-3209 |
|---|---|
| Display | LCD |
| Resistance Range | 200Ω/2kΩ/20kΩ/200kΩ/2MΩ/20MΩ |
| Diode Test | Yes |
| Continuity Buzzer | Yes |
| hFE Test | Yes |
| Auto Power Off | Yes |
| Data Hold | Yes |
| Category | Digital Multimeter |
| Type | Digital Multimeter |
| Digits | 3-1/2 |
| DC Voltage Range | 200mV/2V/20V/200V |
| DC Voltage Accuracy | ±(0.5% + 2) |
| DC Current Range | 200uA/2mA/20mA/200mA/10A |
| DC Current Accuracy | ±(1.0% + 2) |
| AC Current Range | 200mA/10A |
| Resistance Accuracy | ±(0.8% + 2) |
| Capacitance Range | 2nF/20nF/200nF/2uF/20uF |
| Frequency Range | 20kHz |
| Frequency Accuracy | +/-1.5%rdg +/-5dgts |
| Sampling Rate | 3 times/sec |
| Battery | 9V |
General protection against electric shock and proper use precautions.
Explanation of symbols used in the manual and on the meter.
Guidelines for safe maintenance and battery replacement.
Identification and description of the meter's components.
Explanation of the symbols and indicators on the LCD screen.
General specifications and features of the meter.
Detailed technical specifications for AC current, DC current, and DC voltage.
Technical specifications for AC voltage measurement.
Technical specifications for Low Impedance Voltage measurement.
Technical specifications for frequency measurement (Pass V and Clamp Head).
Technical specifications for resistance measurement.
Technical specifications for capacitance measurement.
Specifications for diode test and continuity testing.
Technical specifications for temperature measurement.
Steps to prepare the meter for measurement and power on.
How to use the data hold function to lock readings.
Instructions for using the backlight and flashlight features.
Explanation of the auto power-off function and how to wake the meter.
Step-by-step guide for measuring AC or DC current using the clamp head.
Procedure for performing non-contact voltage detection.
Detailed instructions for measuring DC and AC voltages.
How to perform low impedance voltage measurements.
Steps for measuring frequency using voltage and current clamp modes.
Guide to measuring electrical resistance.
Procedure for testing diodes.
How to perform continuity tests with audible beeps.
Instructions for measuring capacitance.
Steps to measure temperature using the thermocouple.
Step-by-step guide for replacing the meter's batteries.
Guidelines for replacing damaged or worn test leads.
To Next Page
