Mon
I In .
Set At
I
LI- LI 1 n
AM
I
Temperature
SYSTEM
COOL OFF HEAT
FAN
ON AUTO
PROGRAMMING THE THERMOSTAT
Filter Change Reminder
If your installing contractor has configured
the thermostat to remind you when the air
filter needs changed, you will see
FILT
in the
display when your air filter needs changed.
FILT
will be shown in the display after your
system has run long enough to require an air
filter change.
Resetting the filter change reminder: When
FILT
reminder is displayed, you should
change your air filter and reset the reminder
by holding down the second button from the
top left side of the thermostat for 3 seconds.
Hold down for 3 seconds,
to reset filter reminder.
Temporary and Permanent Hold Feature
Temporary hold: The thermostat will display
HOLD
and
RUN SCHED on the left
of your
screen when you press the
or
key.
If you do nothing, the temperature will remain
at this setpoint temporarily until the next
program period begins. Your program
setpoint will then replace your temporary
setpoint.
Permanent hold:
If
you press
HOLD,
you will
see
HOLD
appear below the setpoint tem-
perature in the display. The thermostat will
now permanently stay
at this
setpoint and can
be adjusted using the
or
keys.
To return to program: Press
RUN SCHED
to
exit either temporary or permanent hold.
Understanding Thermostat Staging
Your thermostat will control two stages of
heating and cooling. The thermostat will try to
maintain your comfort setting using the first
stage for energy efficiency. The second stage
of heating or cooling will only be used if your
thermostat cannot maintain your comfort
setting using only one stage. When the second
stage is used you will see
+1
in the display.
To Next Page
Loading...
