15
- Inspect for cracked, bent or
broken spokes.
- Inspect for signs of rough edges
or peeling.
X
X
- Inspect wheel/fork assembly for
proper tension by spinning
caster; caster should come to a
gradual stop.
- Adjust bearing system if wheel
wobbles noticeably or binds to a
stop. Ensure wheel bearings are
clean and free of moisture.
- Check head tube locknuts for
tightness.
- Inspect casters for cracks and
wear (hub and rim)
- Inspect for cracked or broken
spokes.
CAUTION: As with any vehicle, the
wheels and tires should be checked
periodically for cracks and wear, and
should be replaced if damaged
X
X
X
X
X
X
X
X
X
X
- Clean upholstery and armrests
X
X
MAINTENANCE SAFETY PRECAUTIONS
WARNING
Unless otherwise noted, all service adjustments should be performed while the
wheelchair is unoccupied.
After ANY adjustments, repair or service and BEFORE use, make sure all attachment
hardware is tightened securely- otherwise, injury or damage may result.
When cleaning rear cane or handgrip areas use only a clean towel lightly dampened
with cool water. Verify that grips are dry prior to use. DO NOT use soap or ammonia
based cleaning solutions otherwise the handgrips will slide off the cane assembly.
Failure to observe this warning may result in injury to the user or bystanders.
CAUTION
DO NOT over tighten hardware attaching to the frame. This could cause damage to
the frame tubing.
To Next Page
Loading...