Procom QN300TYLA User Manual

1
OWNER
’
S OPERATION AND INSTALLATION MANUAL
COMPACT L.P.& NATURAL
GAS VENT-FREE STOVE
WARNING: If the information in this
manual is not followed exactly,a fire or
explosion may result causing property
damage, personal injury, or loss of life.
WARNING: This is an unvented gas-
fired heater. It uses air (oxygen) from the
room in which it is installed. Provisions
for adequate combustion and ventilation
air must be provided. Refer to Air For
Combustion and Ventilation section on page
4 of this manual.
WARNING: Improper installation, adjustment,
alteration, service or maintenance can cause in-
jury or property damage. Refer to this manual for
correct installation and operational procedures. For
assistance or additional information consult a
qualified installer, service agency, or local gas supplier.
This appliance may be installed in an aftermarket*,
permanently located manufactured (mobile) home,
where not prohibited by local codes.This appliance
is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use
with other gases.
*Aftermarket: Completion of sale, not for purpose of resale,
from the manufacturer.
QN300TYLA QL300TYLA
QN220TYLA QL220TYLA
Table of Contents
Safety information warnings----------------------2
Air for conbustion & Ventilation-----------------4
Installation----------------------------------------------6
Installing Blower Accessory---------------------10
Operation Heater------------------------------------12
Troubles hooting-------------------------------------15
Parts Breakdown & Parts List------------------18
Log Placing Instructions--------------------------22
CINTINENTAL APPLIANCE INC
5 Musick 4600 Highlands Parkway S.E.
Irvine Suite # D/E
CA 92618 Smyrna, GA 30080
TOLL-FREE NUMBER: 1-877-886-5989
Consumer : please retain these instruction for
future use.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
 Do not try to light any appliance.
 Do not touch any electrical switch; do not
use any phone in your building.
 Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
 If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
qualified installer, service agency, or local gas
supplier.
WATER VAPOR:A BY-PRODUCT OF UNVENTED ROOM
HEATERS
Water vaporis a by-product of gas combustion.An unvented
room heater produces approximately one(1)ounce (30)ml
of water for every 1,000BTU’S (3KW’S) OF gas input per
hour,Refer to papg 6.
Installer:Please leave these instructions with the
consumer.

Procom QN300TYLA Specifications

General

Brand	Procom
Model	QN300TYLA
Category	Stove
Language	English

Summary

General Safety Information

Critical Safety Warnings

Essential warnings about fire, explosion, CO, gas leaks, and operational hazards during use and installation.

Safe Operation and Placement

Guidelines for safe usage, clearances, ventilation, supervision, and prohibited installation locations.

Installation and Maintenance Safety

Focuses on safe servicing, altitude limits, log condition, fuel tank size, and specific state regulations.

Product Features and Preparation

Key Safety and Ignition Features

Explains the Oxygen Depletion Sensing (ODS) safety pilot and the Piezo ignition system.

Unpacking and Local Code Compliance

Guidance for unpacking the appliance and adhering to applicable local regulations.

Combustion Air and Ventilation

Ventilation Requirements by Space Type

Defines ventilation needs for confined, unconfined, and unusually tight construction spaces.

Methods for Providing Ventilation Air

Describes how to supply necessary fresh air from inside or outside the room.

Installation and Gas Connection

Clearances and Gas Supply Setup

Details minimum wall/ceiling clearances and connecting the gas supply line safely.

Gas Connection Testing and Safety

Outlines leak testing procedures and essential safety checks for gas connections.

Installing the Log Set

Provides step-by-step guidance for correctly placing the logs within the firebox.

Blower Accessory Installation

Mounting and Wiring the Blower

Instructions for attaching blower components and connecting wires to the heater.

Blower Operation and Electrical Safety

Covers blower control modes, operation, and proper electrical grounding.

Heater Operation and Care

Lighting and Operating Procedures

Step-by-step guide for safely lighting the pilot and main burners, and adjusting operation.

Cleaning and Maintenance Schedule

Routine procedures for cleaning critical parts like the burner, pilot, and unit exterior.

Troubleshooting Guide

Ignition and Pilot Light Issues

Solutions for problems like no spark, no ignition, or pilot outages.

Burner Flame and Performance Problems

Addresses issues such as delayed ignition, backfiring, yellow flames, and noise.

Odor, Shutoff, and Gas Leak Detection

Troubleshooting steps for unwanted odors, ODS shutoffs, and detecting gas leaks.

Parts Information

Illustrated Parts Identification

Visual diagrams used to identify various heater components.

Detailed Parts List by Model

A comprehensive list of parts and their quantities for different heater models.

Log Set Installation Specifics

Step-by-Step Log Placement Guide

Detailed visual instructions for correctly positioning the logs on the firebox assembly.