Procom QL300TYLA User Manual

1
OWNER
’
S OPERATION AND INSTALLATION MANUAL
COMPACT L.P.& NATURAL
GAS VENT-FREE STOVE
WARNING: If the information in this
manual is not followed exactly,a fire or
explosion may result causing property
damage, personal injury, or loss of life.
WARNING: This is an unvented gas-
fired heater. It uses air (oxygen) from the
room in which it is installed. Provisions
for adequate combustion and ventilation
air must be provided. Refer to Air For
Combustion and Ventilation section on page
4 of this manual.
WARNING: Improper installation, adjustment,
alteration, service or maintenance can cause in-
jury or property damage. Refer to this manual for
correct installation and operational procedures. For
assistance or additional information consult a
qualified installer, service agency, or local gas supplier.
This appliance may be installed in an aftermarket*,
permanently located manufactured (mobile) home,
where not prohibited by local codes.This appliance
is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use
with other gases.
*Aftermarket: Completion of sale, not for purpose of resale,
from the manufacturer.
QN300TYLA QL300TYLA
QN220TYLA QL220TYLA
Table of Contents
Safety information warnings----------------------2
Air for conbustion & Ventilation-----------------4
Installation----------------------------------------------6
Installing Blower Accessory---------------------10
Operation Heater------------------------------------12
Troubles hooting-------------------------------------15
Parts Breakdown & Parts List------------------18
Log Placing Instructions--------------------------22
CINTINENTAL APPLIANCE INC
5 Musick 4600 Highlands Parkway S.E.
Irvine Suite # D/E
CA 92618 Smyrna, GA 30080
TOLL-FREE NUMBER: 1-877-886-5989
Consumer : please retain these instruction for
future use.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
 Do not try to light any appliance.
 Do not touch any electrical switch; do not
use any phone in your building.
 Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
 If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
qualified installer, service agency, or local gas
supplier.
WATER VAPOR:A BY-PRODUCT OF UNVENTED ROOM
HEATERS
Water vaporis a by-product of gas combustion.An unvented
room heater produces approximately one(1)ounce (30)ml
of water for every 1,000BTU’S (3KW’S) OF gas input per
hour,Refer to papg 6.
Installer:Please leave these instructions with the
consumer.

Procom QL300TYLA Specifications

General

Brand	Procom
Model	QL300TYLA
Category	Stove
Language	English

Summary

WATER VAPOR CONSIDERATIONS

SAFETY INFORMATION WARNINGS

General Safety Precautions

Covers hazards like hot surfaces, flammable materials, supervision, and proper component use.

Gas Leak Procedures

Procedures to follow if a gas leak is suspected, including immediate actions.

Usage Restrictions

Lists locations and conditions where the heater should not be used.

Operational and Maintenance Warnings

Advice on servicing, altitude operation, fuel, and specific product interactions.

PRODUCT FEATURES

Safety Pilot System

Details the Oxygen Depletion Sensing (ODS) safety shutoff system.

Piezo Ignition System

Explains the matchless piezo ignition system for lighting the heater.

AIR FOR COMBUSTION AND VENTILATION

Ventilation Classifications

Defines space classifications (tight construction, unconfined, confined) for ventilation needs.

Determining Fresh-Air Flow

Worksheet and method to calculate required fresh air for heater installation.

INSTALLATION

Clearances to Combustibles

Specifies minimum distances to walls, ceilings, and other objects for safe installation.

Connecting to Gas Supply

Instructions for safely connecting the heater to the gas supply line.

Installation Items Needed

Lists all necessary tools and components required before starting installation.

Checking Gas Connections

Procedures for verifying gas line integrity and leak detection after installation.

Installing Blower Accessory

OPERATING HEATER

Lighting Instructions

Step-by-step guide on how to safely light the pilot and main burners.

Manual Lighting Procedure

Alternative method for lighting the pilot using a match if the ignitor fails.

THERMOSTAT CONTROL OPERATION

Inspecting Burners

Instructions on checking pilot and burner flame patterns for correct operation.

Cleaning and Maintenance

Procedures for keeping the heater clean and ensuring its longevity and performance.

MAIN BURNER

Specifications

Technical specifications including BTU output, gas type, dimensions, and weight.

TROUBLESHOOTING

No Spark from ODS/Pilot

Addresses issues where the ignitor button is pressed but no spark occurs.

ODS/Pilot Lights but Flame Goes Out

Solutions for when the pilot lights but the flame extinguishes upon release of the control knob.

Spark but No Ignition

Troubleshooting steps when a spark is present but the pilot or burner does not ignite.

ILLUSTRATED PARTS BREAKDOWN

Parts List

Detailed list of replacement parts with part numbers and quantities for different models.

PLACING INSTRUCTION

Q SERIES LOG SET INSTALLATION INSTRUCTIONS

Log Placement Guide

Detailed visual guide for correctly positioning each log in the set.