PROEL M1500 - Technical Specifications; Specifiche Tecniche

31
ENG ITA
TECHNICAL SPECIFICATIONS SPECIFICHE TECNICHE
Section Levels & Data Connectors
MONO INPUT CHANNEL
Mic Input
sensitivity from 0 to -60 dB
Balanced XLR-F
impedance 2 Kohm
Line Input
sensitivity from +20 to -40 dB
Balanced Jack
impedance 10 Kohm
EQ
HIGH ±15 dB @ 12 KHz shelving
MID ±15 dB peaking
FREQ 100 Hz ÷ 8 KHz Q=1.8
LOW ±15 dB @ 80 Hz shelving
STEREO INPUT CHANNEL
Mic Input
sensitivity from 0 to -40 dB
Balanced XLR-F
impedance 2 Kohm
Line Input
sensitivity from +20 to -20 dB
Balanced Jack
impedance 10 Kohm
EQ
HIGH ±15 dB @ 12 KHz shelving
HI MID ±15 dB @ 3 KHz peaking
LO MID ±15 dB @ 500 KHz peaking
LOW ±15 dB @ 80 Hz shelving
MASTER SECTION
MAIN MIX nom. out level +4 dBu Balanced Jack
GROUP 1-2 / 3-4 nom. out level +4 dBu Balanced Jack
C. ROOM output nom. out level +4 dBu Unbalanced Jack
AUX 1 OUT nom. out level +4 dBu Unbalanced Jack
AUX 2 OUT nom. out level +4 dBu Unbalanced Jack
AUX 3 / 4 OUT nom. out level +4 dBu Unbalanced Jack
2-TRK
nom. out level 0 dBu Unbalanced Rca
nom. in level -10 dBv Unbalanced Rca
HEADPHONES
min. impedance 32 ohm
Stereo Jack
max. out level (2x) 193 mW
BUILT-IN POWER AMPLIFIER
EIAJ 1KHz 1% dist. both ch. driven 750+750 W (4ohm min. load) 2x Speakon
DIGITAL EFFECT PROCESSOR (DUAL)
Presets HALL, ROOM, VOCAL and PLATE reverbs
STEREO, MONO and TAP delays
CHORUS and FLANGER modulations
REV + STEREO DELAY, REV + MONO DELAY,
REV +CHORUS and REV + FLANGER combinations
Variations Each Preset has 16 parameter variations
Controls MUTE switch, TAP switch, MUTE pedal, TAP pedal
USB INTERFACE
Version Fully compliant with USB 1.1
Resolution 16-Bit Delta Sigma ADC and DAC
Sampling Rate DAC: 32, 44.1, 48 kHz
ADC: 8, 11.025, 16, 22.05, 32, 44.1, 48 kHz
GENERAL SPECIFICATIONS
Maximum level all outputs +22 dBu
Crosstalk meas. at 1 KHz > 82 dBu
HUM & Noise unweighted < -93 dBu
Sezione Livelli e Dati Connettori
CANALE INGRESSO MONO
Ingresso Mic
sensibilità da 0 a -60 dB
XLR-F Bilanciato
impedenza 2 Kohm
Ingresso Line
sensibilità da +20 a -40 dB
Jack Bilanciato
impedenza 10 Kohm
EQ
ALTI ±15 dB @ 12 KHz shelving
MEDI ±15 dB @ 2.5 KHz peaking
FREQUENZA 100 Hz ÷ 8 KHz Q=1.8
BASSI ±15 dB @ 80 Hz shelving
CANALE INGRESSO STEREO
Ingresso Mic
sensibilità da 0 a -40 dB
XLR-F Bilanciato
impedenza 2 Kohm
Ingresso Line
sensibilità da +20 a -20 dB
Jack Bilanciato
impedenza 10 Kohm
EQ
ALTI ±15 dB @ 12 KHz shelving
MEDIO ALTI ±15 dB @ 3 KHz peaking
MEDIO BASSI ±15 dB @ 500 Hz peaking
BASSI ±15 dB @ 80 Hz shelving
SEZIONE MASTER
MAIN MIX liv. nom. uscita +4 dBu Jack Bilanciato
GROUP 1-2 / 3-4 liv. nom. uscita +4 dBu Jack Bilanciato
C. ROOM output liv. nom. uscita +4 dBu Jack Sbilanciato
AUX 1 OUT liv. nom. uscita +4 dBu Jack Sbilanciato
AUX 2 OUT liv. nom. uscita +4 dBu Jack Sbilanciato
AUX 3 / 4 OUT liv. nom. uscita +4 dBu Jack Sbilanciato
2-TRK
liv. nom. uscita 0 dBu Rca Sbilanciato
liv. nom. ingr. -10 dBv Rca Sbilanciato
HEADPHONES
impedenza min. 32 ohm
Jack Stereo
uscita massima (2x) 193 mW
AMPLIFICATORE DI POTENZA INTERNO
EIAJ 1KHz 1% dist. 2 canali in funz. 750+750 W (4 ohm minimo) 2x Speakon
DIGITAL EFFECT PROCESSOR (DOPPIO)
Preset riverberi HALL, ROOM, VOCAL e PLATE
delay STEREO, MONO e TAP
modulazioni CHORUS e FLANGER
combinazioni REV + STEREO DELAY, REV + MONO DELAY,
REV +CHORUS e REV + FLANGER
Variazioni Ogni preset ha 16 variazioni di parametri
Controlli tasto MUTE, tasto TAP, pedale MUTE, pedale TAP
INTERFACCIA USB
Versione Compatibile con speci che USB 1.1
Risoluzione 16-Bit Delta Sigma ADC e DAC
Frequenza di
campionamento
DAC: 32, 44.1, 48 kHz
ADC: 8, 11.025, 16, 22.05, 32, 44.1, 48 kHz
SPECIFICHE GENERALI
Livello Massimo tutte le uscite +22 dBu
Diafonia mis. a 1 KHz > 82 dBu
Ronzio e Rumore non pesato < -93 dBu
TECHNICAL SPECIFICATIONS
SPECIFICHE TECNICHE