PROEL RM3000TR - Set up a Second Receiver; Set up a Second System; Set up the Channels to Avoid Intermodulation

11
SETTINGUPASECONDRECEIVER
Afteryouhavesetthefirstreceiverandtransmitter,leavingONthetransmitterrepeattheoperation
forthesecondreceiver:


SETTINGUPASECONDSYSTEM
IfyouneedtouseasecondSYSTEM(receiverandtransmitter)inthesameapplication,youhaveto
setatransmissionchanneldifferentfromthatusedinthefirstsystem.Thechannelusedforthe
secondsystemmustNOTbeadjacenttothechannelusedforthefirstone,otherwisethetwo
systemswillnotwork.


SETTINGUPOTHERCHANNELS
Ifyouareusingtwoormorewirelesssystemsinthesamefrequencyrange(863–865MHz),follow
thissimplemethodinordertocheckifthereisanyinterferencebetweenthem.
x Turnonallthetransmittersandsendadifferentsignalthrueachofthem.
x Checkthereceiversoneatatimeandverifyiftheyworkproperlyandifeachofthem
receivestherightsignalwithoutinterferencesfromothertransmitters.
