13
AIR COMPRESSOR
This unit is equipped with an air compressor (260 PSI /18 BAR) for a variety of applications such as vehicle tyres
and sports equipment.
CAUTION: Be careful not to over-inflate, monitor the compressor display while inflating. Never connect or
disconnect the nozzle while the compressor is running. To avoid overheating, do not run the air compressor for
more than 10 minutes at a time. Allow the air compressor to cool down for 15 minutes after use before using it
again.
OPERATION
If the vehicle tyre is completely flat, lift the vehicle with a recommended jack before inflating the tyre.
1. Ensure that the tyre is inflated to the manufacturer's recommended pressure before inflating the tyre.
2 Open the compartment door at the rear of the power dome and extend the air hose.
3. Position the power dome so that you can see the pressure gauge.
4. Make sure that the chuck lever is positioned upwards (away from the chuck opening).
5. determine if you need an air hose adapter for your object.
For inflating a vehicle tire:
a. Remove the valve cap from the tire valve stem.
b. Attach the collet of the air tube to the valve stem of the tire.
c. Push the chuck lever down to secure the chuck to the valve stem.
For inflating sports equipment, air mattresses or other inflatable plastic parts:
a. Insert the appropriate valve stem adapter as far as possible into the stem connector.
b. Push the chuck lever down to secure the adapter.
c. Remove the valve cap from your inflatable object, if present.
d. Insert the other end of the valve stem adapter as far as possible into the air valve opening of the
inflatable object.
6. Set the air compressor switch to the "I" position to start inflation.
7. Monitor the pressure gauge while inflating the tire.
8. When the recommended tire pressure is reached, turn off the air compressor.
9. Remove the inner tube and replace the valve cap.
10. Return the tube to its compartment for storage.
11. Recharge the energy station as soon as possible.
VOLTAGE CONVERTER
The device can supply most alternating current (AC) devices with power up to a maximum of 400 watts.
The operating time depends on the wattage of the connected device and the current state of charge of the
battery.
Lower wattages and a fully charged battery will result in a longer operating time. Overloads cause the inverter
to switch off automatically. Reduce the load and restart the inverter. There is a user-replaceable fuse that
protects the inverter from unlikely excessive power consumption or short circuit. REPLACE ONLY WITH A FUSE
OF THE SAME TYPE AND RATING. Replace the fuse by simply pulling it out with pointed pliers and inserting the
new fuse.
CAUTION
Some rechargeable devices are equipped with a separate AC charger. These devices can be is expected to work
well with the inverter in this unit. Rechargeable devices that use built-in chargers (refer to your device's user
manual) may not work properly with this device because the inverter has a modified sine wave. Some motorized
devices may operate at excessively high temperatures in conjunction with this inverter. When using with this
inverter for the first time, be aware of excessive motor temperature. An abnormal increased temperature of the
device is an indication that they should not be used together
OPERATION
1. Check the required current consumption of the device to be supplied and make sure not to exceed the
maximum wattage of the power station.
2. Before connecting your device, turn off your power tool or device.
To Next Page
Loading...