Proficook PC-MCM 1024 - Maintenance and Troubleshooting; Cleaning Instructions; Troubleshooting Guide

65
Cleaning
WARNING:
• Beforecleaningalwaysdisconnectfrommains
power supply.
• Undernocircumstancesshouldyouimmerse
the device in water for cleaning purposes.
Otherwisethismightresultinanelectricshock
or fire.
• Themixerbladesaresharp!Riskofinjury!
CAUTION:
• Donotuseawirebrushoranyabrasiveitems.
• Donotuseanyacidicorabrasivedetergents.
• Themixingjugisnotdishwashersafe.
• Donotrinsethemixingjuginabowlofwater
either.Thebaseofthemixingjugcontains
electroniccomponentsthatmustnotgetwet!
• Shouldwaterhoweverpenetratethebaseof
themixingjug,allowtodrycompletelybefore
you use it again.
For cleaning the outside of the machine use only a
damp washing-up cloth.
Mixing jug
1. Fillthemixingjugwithabout1literwaterby
adding a few drops of dishwashing liquid.
CAUTION:
Water with dishwashing liquid will foam up dur-
ingheatingandmixing.
2. Heat up the water for about 8 minutes at cook-
ing setting HIGH.
3. Press the PULSE button briefly.
4. Allow the water to cool before cleaning the
insidewallofthemixingjug.
5. Cleanthemixingjugfromtheinsidewiththe
cleaning brush provided.
6. Rinseoffthemixingjugwithcleanwaterand
carefully dry it off.
Lid and cap
1. Clean these components in a rinsing bath.
2. Rinse with clean water.
3. Dry the parts off.
Storage
• Cleanthedeviceasdescribed.Lettheacces-
sories dry completely.
• Werecommendthatyoustorethedeviceinits
original packaging when it is not to be used for a
longer period.
• Alwaysstorethedeviceatawellventilatedand
dry place outside the reach of children.
Troubleshooting
Mal-
function
Possible cause Remedy
The
device
does not
function.
The device is
not supplied
with power.
Check the outlet
with a different
device
Insert the power
plug correctly.
Check your
domestic fuse.
The safety
switch is not
closed.
Check that the
mixingjugand
the lid are fitted
correctly.
The device is
defective.
Contact our
Service or a
specialist.
Liquids
are not
mixedcor-
rectly.
You have too
much or too
little liquid in the
vessel.
Vary the quantity
of the liquid.
The speed is
too high.
Start with a lower
speed which you
can increase
later.
The
blades
become
blocked
after turn-
ing on.
The selected
speed is too
low.
Start at a higher
speed.