11
USING THE CONTROLLER
POWER
Once the drone is turned on, press the power button on the drone to turn it on.
The controller will automatically connect to the drone, and once successfully
connected the drone will change from flashing quickly to flashing slowly.
JOYSTICKS
Use to control the drone, following the information on the previous page.
SPEED DIAL
Use the SPEED DIAL to change the flight mode from Low Speed (Beginner) to High
Speed (Advanced). The display on the controller will indicate the currently selected
speed mode (R.H = High Speed, L.H = Low Speed)
PHOTO/VIDEO BUTTON
To use the Photo and video functions from the controller, a suitable MicroSD card
must be correctly inserted into the rear of the camera.
Photo: Press once to take a photo.
Video: Press and hold for 2 seconds to start recording a video. The video symbol
will show on the display. To stop recording, press and hold the video button for 2
seconds again. Note if power is disconnected during recording the video file will
be corrupted.
COMPASS CORRECTION BUTTON
Press and hold the compass correction button for approx. 2 seconds until the
controller bleeps. The LED’s on the drone will flash quickly. Pick up the drone and
hold it around 1 meter from the ground and with the base facing the ground. Turn
the drone clockwise repeatedly (approx. 3-6 full rotations) until the controller
emits a sound. Then hold the drone vertically with the camera facing the ground
and turn clockwise again until the controller emits a long sound indicating compass
correction has been successful.
GYROSCOPIC CORRECTION BUTTON
Place the drone on a flat surface. Press the gyroscopic calibration button and the
drone will flash quickly. This indicates that calibration has been successful. You can
now search for GPS signals by pressing the GPS button.
GPS BUTTON
Press to turn the GPS Feature on and off. Note when GPS is turned off, or the GPS
signal is insufficient a number of features are deactivated.
To Next Page
Loading...
