ProForm 831.295062 - User Manual

Questions and Answers

S
samantha27Aug 17, 2025
How to troubleshoot ProForm Treadmill power not turning on?
- J
  John BlakeAug 17, 2025
  To troubleshoot a ProForm Treadmill that won't power on, ensure the power cord is plugged into a surge suppressor (meeting specific requirements) and that the suppressor is in a grounded outlet. Note that the treadmill isn't compatible with GFCI outlets. Also, ensure the key is fully inserted into the console. Finally, check the reset/off circuit breaker on the treadmill frame near the power cord. If it protrudes, the breaker tripped; wait five minutes, then press it back in to reset.
N
Nathan CummingsAug 23, 2025
How to recalibrate the incline on a ProForm 831.295062 Treadmill?
- M
  Mark WaltonAug 23, 2025
  To recalibrate the incline system on your ProForm Treadmill, insert the key into the console and press one of the Incline buttons. While the incline is changing, remove the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level.
R
Ronald ChavezAug 30, 2025
What to do if my ProForm 831.295062 power turns off during use?
- T
  Tony HopkinsAug 30, 2025
  If your ProForm Treadmill turns off during use, check the reset/off circuit breaker and reset it if tripped by waiting five minutes before pressing the switch back in. Ensure the power cord is securely plugged in; if so, unplug it, wait five minutes, and plug it back in. Also, remove and reinsert the key fully into the console. If these steps do not resolve the issue, please call toll-free 1-800-4-MY-HOME (1-800-469-4663).
C
Caitlyn HerreraNov 10, 2025
How to fix a ProForm 831.295062 walking belt that is off-center or slips?
- K
  Kevin WilliamsonNov 10, 2025
  If your ProForm Treadmill's walking belt is off-center, first remove the key and unplug the power cord. If the belt has shifted left, turn the left rear roller bolt clockwise 1/2 turn with an allen wrench. If it has shifted right, turn the bolt counterclockwise 1/2 turn. Avoid overtightening. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat this process until the belt is centered. If the walking belt slips when walked on, first remove the key and unplug the power cord. Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each side of the walking belt 2 to 3 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power co...