7
1. Attach a Rubber Spacer (29) and a Foot (13) to
the Lower Upright (1) with an M10 x 35mm
Screw (34).
Next, locate the Wire Harness (43) inside the
Lower Upright (1). Connect the Wire Harness to
the base wire as shown. Then, pull the Wire
Harness out of the top of the Lower Upright.
43
1
1
34
13
29
Base
Wire
43
Before beginning assembly, carefully read the
following information and instructions:
• To hire an authorized service technician to
assemble the vibration platform in your home, call
1-800-445-2480.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• For help identifying small parts, see the PART
IDENTIFICATION CHART on page 6.
• Tighten all parts as you assemble them, unless
i
nstructed to do otherwise.
• Assembly may require the following tools (not
included):
one adjustable wrench
one rubber mallet
one Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
This manual is designed to ensure that the
v
ibration platform can be assembled successful-
ly by almost anyone. Most people find that if
they set aside plenty of time, assembly goes
smoothly.
ASSEMBLY
To Next Page
Loading...
Need help?
General
