4. Move your right hand to the position shown at the right,
and hold the treadmill firmly. Using your left hand, lift the
storage latch. Raise the treadmill until the locking pin
snaps into the storage latch. Make sure that the locking
pin is inside the storage latch, and that the storage
latch is fully closed.
.
Stand behind the treadmill. Hold the Right Crossbar
Bracket (51) and the Left Crossbar Bracket (not shown).
Place one foot on the base in the indicated location.
Tip the treadmill back slightly. While the treadmill is held
in this position, a second person should slide the
Stabilizer Plate (88) onto the base (see the inset draw-
ing).
Keeping your foot on the base, carefully tip the treadmill
back until it is resting on the base. Make sure that the
Stabilizer Plate (88) stays on the base.
Attach the Stabilizer Plate (88) to the base with a
Stabilizer Plate Bolt (105), two Washers (72), and a Nut
(26) as shown.
.
See assembly step 4. Hold the upper end of the treadmill
with your right hand as shown. Using your left hand, lift
the storage latch. Pivot the treadmill slightly until the lock-
ing pin is out of the storage latch.
Hold the treadmill firmly with both hands, and lower the
treadmill to the floor. To decrease the possibility of in-
jury, bend your legs and keep your back straight.
7. Remove the paper backing from the Adhesive Clip (44).
Press the Adhesive Clip onto the Frame (120) in the indi-
cated location. Press the 3/16" Allen Wrench (57) into the
Adhesive Clip. The use of the 3/16" Allen Wrench is de-
scribed on page 12.
Make sure that all parts are tightened before you use the
treadmill. Note: To protect the floor or carpet from dam-
age, place a mat under the treadmill.
Pin
5 51
Base _
26
105
88
7
57 120
To Next Page
Loading...
