DIAGRAMOFTHECONSOLE
;O s"
t_ INSERT
_71_p If KEY
_ r
FAST
o
o
o
o
o
o
o
SLOW
_ RES
_ SET
Key
$PEEO
[ .so
ON_LF_R
Note: If there'is a thin
sheet of clear plastic
on the face of the
console, remove it.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the power
cord is properly plugged in. (See HOW TO PLUG IN
THE POWER CORD on page 7.)
The console requires two "AA" batteries (not in-
cluded); alkaline batteries are recommended. Open the
battery cover as shown in the drawing at the upper right,
Press two batteries into the battery compartment, with
the negative (-) ends of the batteries touching the
springs. Close the battery cover.
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing a.t the top of
this page), and slide the clip onto the waistband of your
clothing.
Follow the steps below and on page 9 to operate the
console.
a
Insert the key fully into the power switch.
Inserting the key will not
turn on the displays. The
displays will turn on
when the ON/CLEAR
button is pressed or the
walking belt is started.
Note: If you just installed
,!
batteries, the displays will already be on.
To Next Page
Loading...
