3
GENERAL SAFETY INFORMATION
: This heater requires a hardwire installation (no plug). The installation of
this product must be carried out by a certified electrician and in accordance with all local
and national electrical codes.
NOTE: This appliance is compatible with a 240V line voltage single pole wall thermostat
(not included). This heater must be installed by a certified electrician.
: Read and understand all installation and operation instructions prior to
operating this unit. Observe all safety instructions at all times.
1. Use only copper wires rated for at least 75ºC.
2. Heater air flow must be directed parallel to or away from adjacent wall.
3. Observe wall, floor and ceiling clearance requirements.
4. All wiring must be done according to national and local electrical codes in the
United States and Canada. The heater must be grounded as a precaution against
possible electrical shock. Heater circuit must be protected with proper fuses.
5. The mounting structure and the anchoring hardware must be capable of
supporting the weight of the heater and the mounting bracket (if used).
6. All electrical power must be disconnected and the main service box, which must
be locked before connecting, inspecting, cleaning or servicing the heater. This is a
precaution to prevent serious electric shock.
7. This heater is not suitable for use in hazardous locations as defined by the
national fire protection association (NFPA) in the United States. This heater has
hot and arcing sparking parts inside. Do not use it in areas where gasoline paint or
flammable liquids are used or stored.
8. This heater is not suitable for use in corrosive atmospheres such as marine
greenhouses or chemical storage areas.
9. This heater must be mounted at least 8 feet above the floor.
Improper installation or failure to follow the procedures outlined in this
instruction manual can result in serious electrical shock.
To Next Page
Loading...
