The heater is packaged with the wheels unattached. You must attach them before
operating the heater.
WARNING: Only operate the heater in normal upright position with wheels assemblies
attached to the bottom (wheels on the bottom, controls on the top), any other position could
create a hazardous situation.
1. Be sure the heater is unplugged and off.
2. Turn the heater body upside down on a scratch-free and stable surface make sure it is
stable and will not fall. (see Fig 1)
3. Screw off the wing nut from the U-shaped bolts provided. Fit the wheel assemblies onto
the heater by placing the U-shaped bolts over the base pipe, between the outermost fins
on each side of the heater. (see Fig.2,3,4).
4. Securely fasten the wheel assemblies onto the heater by screwing the wing nuts onto
the bolts (see Fig. 5).
NOTE: It is normal when the heater is turned on for the first time or after having not been
used for a long period, the heater may emit some smell and fumes or have some noise
inside, these will disappear when the heater has been on a short while.
1. Before using the heater, make sure that it is on a flat a stable surface. Damage may
occur if it is placed on an incline or decline.
2. Turning the thermostat knob counter-clockwise to the - position and setting the power
control dial to “0” for off. Insert the plug into a 120V AC, 60Hz outlet. Check that the
plug and the socket fit well, then you can operate the appliance.
3. Rotate the thermostat knob clockwise to + position and turn the power switch from “0”
to either “1” for low heating, “2” for medium heating or “3” for high heating.
To Next Page
Loading...
