The elliptical equipment is not sturdy
enough.
1. Make sure both the Adjustable Levelers (57) are
touching the ground.
2. Make sure the elliptical equipment is leveled. Please refer
to
page 24.
The tension adjustment doesn't
1. Undo the buckle of the Clip (101) and then pull the top
strap on the front of the unit away (downward) to
re-tighten the tension belt. See page 23.
The pedal assembly is coming
loose.
1. Make sure the bolt is secured to the foot bar and into the
crank with the nylon nut. When tightening the bolt, make
sure the bolt threads protrude out through the nylon nut.
2. Proper tightness is extremely important to prevent parts
from coming loose or damage during use. See page 12
& 14.
The sensor is not reading correctly.
1. Open the left and right covers and realign the magnet
To Next Page
Loading...