Page 2 Owner’s Handbook
Congratulations on your purchase of a PROHEAT X45 Plus diesel-fired heater. This handbook is provided
to summarize the operation and maintenance of the PROHEAT X45 Plus for the Owner/Operator.
For complete information, please refer to the Installation and Service manual 925860 at www.proheat.com
Although trucks have been used throughout this book, applications for PROHEAT are by no means
limited to trucks. PROHEAT heaters are designed to be used on any diesel equipped vehicle
including: trucks, buses (school, transit and coach), construction equipment, off road equipment,
military equipment and cargo.
PROHEAT heaters are used in the following applications:
• Preheats an engine block to ensure reliable cold weather starting.
It is recommended that PROHEAT is used year round (winter and summer) to reduce engine
wear associated with cold starting.
• With the engine off—supplies heat to the engine and sleeper for comfort and reduced idle time
resulting in cost savings through reduced fuel consumption and engine wear.
• With the engine running—adds heat to the coolant system when the engine does not provide
adequate reject heat for the vehicles interior. PROHEAT can be operated when the engine
is running.
• Provides heat to protect valuable cargo from cold weather damage.
• With the engine off - supplies minimal heat to prevent freezing over long periods of time.
Introduction
Note
eNgiNe Block heat
eNgiNe & Sleeper heat
SupplemeNtal heat
cargo heat
aNti-Freeze heat
To Next Page
Loading...
