Project Source EVERFIELD 21-K822-PS-SSD

Questions and Answers

J
Jodi HughesAug 10, 2025
Why does my Project Source EVERFIELD 21-K822-PS-SSD faucet leak underneath the handle?
- A
  Amanda AvilaAug 10, 2025
  The faucet leaks underneath the handle because the bonnet has come loose or the ceramic cartridge seal is dirty or out of place. To resolve this, move the handle to the OFF position, unscrew the handle screw, and remove the handle. Tighten the bonnet clockwise. If the leak persists, shut off the water supply, remove the bonnet, and lift out the ceramic cartridge. Inspect the seal, remove any debris, and re-seat it if necessary. If the seal is worn, replace the cartridge. Finally, position the cartridge back, screw the bonnet on tightly, and reinstall the handle.
W
William MillerAug 18, 2025
What to do if the Project Source EVERFIELD 21-K822-PS-SSD Plumbing Product water does not completely shut off?
- H
  haleydavidAug 18, 2025
  If the water does not completely shut off, the ceramic cartridge discs are likely worn or have debris trapped inside. To fix this, shut off the water supply, move the handle to the OFF position, unscrew the handle screw, and remove the handle. Remove the bonnet and lift out the ceramic cartridge. Then, position the new ceramic cartridge into the faucet body, tightly screw the bonnet back onto the faucet body, and reinstall the handle.
J
Julian GentryAug 25, 2025
How to fix a Project Source EVERFIELD 21-K822-PS-SSD Plumbing Product faucet that leaks around the aerator?
- D
  dukewillieAug 26, 2025
  If your faucet leaks around the aerator, it's likely that the aerator is incorrectly fitted, dirty, or the small parts inside are improperly installed. To address this, remove the aerator cover from the spout by turning it clockwise, and then remove the aerator and gasket. Inspect the black rubber gasket inside the aerator to ensure it is flat. Reinstall the gasket and aerator, then replace and tighten the aerator cover on the spout.
K
Kenneth OsborneSep 2, 2025
Why does my Project Source Plumbing Product faucet have an improper water pattern?
- M
  Mark GreenSep 2, 2025
  An improper water pattern from your faucet is often due to a dirty aerator or small parts inside the aerator that are improperly installed. You can fix this by removing the aerator cover from the spout by turning it clockwise, and then remove the aerator and gasket. Gently flush the small parts inside the aerator to clear away any debris. Reinstall the gasket and aerator, then replace and tighten the aerator cover on the spout, ensuring all parts are straight and flat.