To Next Page

To Previous Page

STEP 7 – CHARGING

DuringnormalchargingtheLCDscreenwilldefaulttotheVOLTSdisplay;toviewinput

currentpresstheVOLTS/AMPSbutton.

DuringEqualisationandRecondition,theLCDscreenwilldisplayrapidhorizontallines.

STATUS LCD DISPLAY

Equalisation(CalciumOnly)

Recondition(Auto) –––

–––

–––

Recondition(Manual) Rapidhorizontal(scrolling)lines

TheLEDindicatorswillalsoilluminateandflashvarioussignals,indicatingthedifferent

stagesofcharging.Refertopage7foradiscriptionofLEDsignals.

Whenthebatteryisfullycharged,thegreenFULLYCHARGEDLEDwillilluminate.This

isknownasthefloatstageandthechargercanbeleftconnectedtothebatterywithout

overcharging.

IftheredPOWERLEDisflashing,ortheLCDscreendisplaysanerrorsignal,there

isafault;refertothe“Fault&Errors”explanationonpage15ofthismanual.

STEP 8 – DISCONNECTION

Ensurethe240Vmainsswitchisturnedoffandthechargerisdisconnectedfrom

the240Vmainspower.

Battery out of vehicle

RemovetheBLACKlead(batteryclip)fromthebattery.

RemovetheREDlead(batteryclip)frombattery.

Battery in vehicle

Removethechassisconnection.

Removethebatteryterminalconnection.

STEP 9 – CHECK THE ELECTROLYTE LEVEL (CALCIUM MODE ONLY)

Checktheelectrolytelevelandtopupifrequired.

Projecta IC3500 User Manual

Questions and Answers: