Need help?Do you have a question about the Projecta PC1600 and is the answer not in the manual?
General| Input Voltage | 220-240VAC |
|---|---|
| Output Voltage | 6V / 12V |
| Output Current | 16A |
| Boost Rate | 16A |
| Microprocessor Controlled | Yes |
| Desulfation Mode | Yes |
| Battery Type | Lead Acid, AGM, Gel, Calcium |
| Protection Features | Reverse Polarity, Over Voltage, Over Temperature, Short Circuit |
Crucial safety precautions for operating the battery charger, including ventilation and electrical safety.
Stage designed for calcium batteries to restore full service by removing acid stratification.
Adjusts charging profile for calcium batteries, suited for deep discharge and equalisation.
Chargers are spark-free and protected against accidental reverse connections for safer use.
Details the LED signals for different charging stages for PC400 and PC800 models.
Details the LED signals for different charging stages for PC1600 and PC2100 models.
Outlines three options for connecting the charger to the battery (out of vehicle, in vehicle, hard wiring).
Instructions for connecting red (positive) and black (negative) leads to battery terminals.
Guide for connecting to a vehicle battery, considering positive or negative earthing.
Guide on how to start and stop the 24-hour rejuvenation process for battery restoration.
Explanation of six possible error signals, their causes, and recommended remedies.
Guidance on low battery voltage and using booster cables if the BULK LED does not illuminate.
To Next Page
