6
EN
1.1. Opening the packaging
Inspect the packaging first before opening it. If the packaging is damaged, we
recommend that you report this to your supplier. It is however very likely that,
despite slight damage to the packaging, your projection screen is still in good
condition.
1. Cut off the plastic straps.
2. Pull the tape off of the entire length.
Do not use a knife or other sharp object! If you do, you will risk damaging the screen or
the wiring.
3. Remove all of the components from the packaging; make sure that you do not
forget any of the components such as the small bags with mounting materials.
1.2. Contents of the packaging
In addition to the projection screen, you will always find a small bag with mounting
materials and any necessary accessories in each package. In addition, you should also
find these general instructions for projection screens in the packaging and a sheet
containing specific information which you will need for the installation and mounting
of the type of projection screen that you have purchased. On this sheet, for your
specific product, you will also find an overview of the contents of the packaging.
Check the contents of the packaging on the basis of this sheet. If you discover that
you are missing any components, contact your supplier.
1. Unpacking
S
To Next Page
Loading...
Need help?
General