Energy saving function
This function enables your heater to automatically set the most appropriate heat level to ensure optimum
comfort while reducing energy consumption.
When the heat level is set to HIGH If the ambient temperature rises to be 1°C less than the set
temperature, this energy saving function is activated. The heat
level will be changed from a HIGH level to a LOW level.
If the ambient temperature is higher than the set
temperature, the heater will stop heating.
When the heat level is set to
LOW or MEDIUM
If the ambient temperature is higher than the set
temperature, the heater will stop heating.
Tip over shut-off
When the heater is accidentally knocked over, it will shut off. To reset, place the heater in an upright
position, and then continue operation.
Overheat protection
The heater is fitted with a safety device which will switch off the heater in case of overheating. Please
contact a qualified service engineer to continue operating the heater.
CLEANING AND MAINTENANCE
y Make sure that the heater is powered off and unplugged from the mains socket. Allow it to cool before
cleaning.
y Clean the heater with a slightly damp cloth and be sure to completely dry the heater with a soft cloth
before using again.
y Do not use abrasive or chemical cleaning agents.
y Do not immerse the heater in water or any other liquid.
y When not in use, you can store the power cord into the storage box on the side of the heater.
SPECIFICATIONS
Ratings: 220-240V~ 50-60Hz
Ǧ
EN-9
To Next Page
Loading...