The salt container is located beneath the lower rack and should be filled as follows:
Attention!
Only use salt specifically designed for use in dishwashers! All other typesof
salt not specifically designed for use in a dishwasher, especiallytable salt, will
damage the water softener. If damage is caused by the use of unsuitable
salt the Warranty will be VOID, the manufacturer will not be held responsible for
any damage incurred.
Make sure you fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split,
remaining of the bottom of the machine for any period of time, which may cause
corrosion.
After the first wash cycle the control panel light will go out.
A Remove the lower basket and then unscrew and remove the cap from the salt container.
B If you are filling the container for the first time, fill 2/3 of its volume with water (around 500ml).
C Place the end of the funnel (supplied) into the hole and introduce about 1,2kg of salt. It is
Normal for a small amount of water to come out of the salt container.
D Carefully screw the cap back on.
NOTE:
Rinse aid is automatically released during the last rinse, to ensure the best rinse and drying effect.
Only use branded rinse aid. Never fill the rinse aid dispenser with any Other substances (e.g. dishwasher
cleaning agent, liquid detergent). This would damage the appliance.
5
The salt container must be refilled when the salt warning light on the control panel comes on.1.
After the salt container is filled, the indicator light may not go out beforethefirstfullwashcycle.
To Next Page
Loading...
Need help?
General
