To Next PageTo Next Page
Need help?Do you have a question about the Promag WEC200 and is the answer not in the manual?
General| Fiber connector | SC Duplex |
|---|---|
| Fiber Type | Multi Mode |
| Wavelength | 1310nm |
| Transfer Distance | 2km |
| Power Supply | 5V DC |
| Operating Temperature | 0°C to 50°C |
| Humidity | 5% ~ 90% non-condensing |
| Model | Promag WEC200 |
| Type | 10/100Base-TX to 100Base-FX Media Converter |
Details the main functionalities and features of the WEC200 device.
Details how to connect the WEC200 device via a LAN connection.
Describes the pin assignments for the Wiegand data input.
Outlines the pin assignments for relay and input terminals.
Discusses the integration of electric locks with the WEC200, including specifications.
Details the power supply requirements and recommendations for WEC200 and electric locks.
Command to set the output status of Relay 1 on the WEC200.
Command to set the output status of Relay 2 on the WEC200.
Details commands for the EM module (Device Server) used with WEC200.
Command to assign a new IP address to the WEC200 device.
Details the Wiegand interface specification for the 26-bit data format.
Details the Wiegand interface specification for the 30-bit data format.
Details the Wiegand interface specification for the 34-bit data format.
Details the Wiegand interface specification for the 35-bit data format.
Details the Wiegand interface specification for the 37-bit data format.
