Press the POWER/SOURCE button on the sounbar repeatedly to switch to desired
mode. Or press the AUX, OPTICAL, BT, LINE IN, USB button on remote control to turn
to desired mode directly, the mode indicator on front of the sounbar will turn to:
Blue.............................................................................................Bluetooth Mode
Green.............................................................................................LINE IN Mode
Cyan (blue+green)..............................................................................USB Mode
GENERAL OPERATIONS
3.
Press the POWER/SOURCE button on the sounbar or the button on remote control to
power on the sounbar. The LED light effect will light up.
2.
Press and hold the "PAIR" button on the rear side of the subwoofer until the nearby
INDICATOR lamp starts to blink rapidly, then release the button.
Violet (red+blue).............................................................................AUX IN Mode
11
Orange (red+green)................................................................OPTICAL IN Mode
3.
Press and hold the SB PAIR button on the soundbar until the prompt of "Pairing" is heard.
The blinking INDICATOR lamp on the subwoofer also turns solid blue, which indicates
the subwoofer has been connected to the soundbar successfully.
Connect Subwoofer to Soundbar
Note:
Once the connection is established, the subwoofer will connect to the soundbar
automatically when they are powered on on next time. If not, make the connection
between them following the above steps.
Select an Audio Source
Power On the sounbar
1.
Press and hold the POWER/SOURCE button on the sounbar or press the button on
remote to power off the sounbar. The mode indicator on the soundbar will turn red
again. (If the subwoofer has already been connected to the soundbar, the INDICATOR
will turn off and the POWER INDICATOR will turn to solid red.)
1.
Connect one end of the adapter to the DC IN jack on the soundbar, and the other end
into an AC outlet with AC 110~240V; 50/60Hz. The mode indicator will light up in red.
2. Connect one end of the second adapter to the DC IN jack on the subwoofer, and the
other end into an AC outlet with AC 110~240V; 50/60Hz. The POWER indicator on the
subwoofer will light up in red.
Power Off the sounbar
1.
Power on the sounbar as above.
Note:
1. USB mode can be selected only when a USB device is inserted.
2. If you insert a USB device, other playback mode will be switched to USB mode, and audio
tracks stored in it start to play automatically. You can switch to other playback mode by
the operations instructed above.
To Next Page
Loading...
Need help?
General
