ProScan PSP297 - REMOTE CONTROL; Button Functions; Battery Installation and Precautions; Power Control Operations

STANDBY
PAIR
BATTERY INSTALLATION
STALLATION
- Before installation
Remove and discard the insulation tab. Out of the box the Remote Control
has a battery and will be usable after the tab is removed.
-Replace battery for the remote control
1. Push and slide out the battery holder as Figure 1 below.
2. Replace the battery with a new CR2025 button cell with the polarity (+)
side upward.
3. Slide into the battery holder.
BATTERY PRECAUSIONS
• Never recharge the batteries, apply heat to them or take them apart.
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• Do not throw the batteries in fire!
• Attention should be drawn to the environmental aspects of battery disposal.
• If the remote control is not going to be used for a long time, remove the battery
to avoid damage caused by battery leakage corrosion.
POWER CONTROL
- To turn the unit on
• Connect the supplied AC/DC adapter.
• Press STANDBY button to turn on the unit.
- To turn the unit off
• Press STANDBY button on the remote control or hold STANDBY button in
NOTE:
If the unit is not used for a long period of time, disconnect the power adapter.
1
2
3
4
5
6
7
8
10
1. STANDBY
6. /TUNE -
10. BASS +
4. BASS -
8. (mute)
14. /TUNE +
13. EQ ( Equalizer )
2. VOL- ( volume down )
5. TREBLE -
9. VOL+ ( volume up )
3. SOURCE
12. TREBLE +
REMOTE CONTROL
11. PAIR
9
11
12
13
14
the right side of the unit.
6
MO/ST
7. /MO/ST
( play/pause/mono/stereo )