3
Program Schedule
To adjust program schedules
You can program four time periods each day, with different settings for
weekdays and weekends. We recommend the pre-sets (shown in the table
below), since they can reduce your heating/cooling expenses.
Wake - Set to the time you wake up and the
temperature you want during the morning, until
you leave for the day.
Away - Set to the time you leave home and the
temperature you want while you are away (usually
an energy-saving level).
Home - Set to the time you return home and the
temperature you want during the evening, until
bedtime.
Sleep - Set to the time you go to bed and the
temperature you want overnight (usually an
energy-saving level).
NOTE: To temporarily or permanently override any of the above program
schedules, see page 4.
Wake
(6:00 am)
70
°
78
°
Away
(8:00 am)
62
°
85
°
Home
(6:00 pm)
70
°
78
°
Sleep
pm)
62
°
82
°
1 Press Menu on your thermostat.
2 If PROG is displayed, press Select. If
HOLD is displayed, press
, then press
Select. Then ON is displayed, press
Select.
3 Press
or to select the set of days to
edit (MTWTF or SS). Press Select.
4 Press
or to select a schedule
period to edit (Wake, Away, Home, and
Sleep). Press Select.
5 ON is displayed. Press Select to keep the
schedule period on. Or press
and then
Select to turn off the schedule period.
6 Time starts blinking. Press
or to adjust
the schedule period start time. Press Select.
7 Temperature starts blinking. Press
or to
adjust the “Heat” setpoint temperature. Press
Select. Press
or to adjust the “Cool”
temperature setpoint. Press Select.
8 Repeat steps 4 through 7 for the remaining
schedule periods.
9 Press Home when you’re finished to save and
return to the home screen.
To Next Page
Loading...
