hold “▼” button for 3 seconds to receive transmission signal manually.
Max / Min Temperature/Relative Humidity
To check the indoor/outdoor maximum and minimum temperature and humidity, short press the
“MEM” button:
First Time: show the maximum temperature and humidity values.
Second Time: show the minimum temperature and humidity values
Third Time: backto the current temperature and humidity values.
To reset the maximum and minimum temperature and humidity, press and hold down the “MEM” button about 2
seconds.it will reset all minimum and maximum data according to the current displayed values.
F.Y.I.:
If the temperature reading is below ranges, the LL.L will be displayed. If the temperature reading is above ranges,
the HH.H will be displayed.
Remote Temperature Alert Setting:
Press and hold the ” button for 2 seconds until the Temperature Alert " (High)icon starts flashing. Use the “▲”
and “▼” buttons to set the required maximum temperature
Short press ” button and the icon starts flashing , use the “▲” and “▼” buttons to set the required minimum
temperature. Press ” button again to confirm your setting.
F.Y.I.:
Before starting the setup procedures, you must select the remote channel, different channels can set different
temperature alarm ranges.
Temperature and Frost Alert:
Press ” button to turn on or off the remote temperature alert. When the remote temperature alarm is activated, the
alarm icon is displayed on the REMOTE SENSOR column.
The alarm will be activated when outdoor temperature exceeds the preset value. It goes off 5 times within 1 minute, and
the icon " " flashes.
When the temperature of REMOTE SENSOR is beween +30°F to + 37°F or –1°C to + 3°C, the frost alarm will be
activated, Icon " flashes.
Low battery:
The battery symbol ” appears on the LCD screen indicates that the batteries in the remote sensor should be
replaced as soon as possible.
Weather Forecast:
The weather station detects weather conditions for the next 12 hours based on the barometric pressure trend.
Please take the weather forecast from your local weather forecasting service into account as well as the forecast
from your weather station. If there are discrepancies between the information from your device and the local
weather forecasting service, please take the advice of the latter as authoritative.
Selection of the Barometric Pressure Units ( "hPa/mb" or "inHg") : Press and hold the ” button for 2 seconds
until the pressure units startsflashing, use the “▲” or “▼” button to choose desired pressure unit from "hPa/mb"
To Next Page
Loading...