Protocol GALILEO STEALTH User Manual (English)

Questions and Answers:

C
Crystal SanchezAug 8, 2025
What to do if my Protocol GALILEO STEALTH Drones Dronium III AP does not respond?
- L
  Louis SchwartzAug 8, 2025
  If your Protocol Drones Dronium III AP isn't responding, it might be due to a couple of reasons. First, the communication between the controller and the aircraft might not have been correctly synchronized during setup. To fix this, turn on the aircraft first, place it on level ground, and then turn on the controller. Another possibility is that the battery power is low on either the aircraft or the controller. Make sure to charge the aircraft and replace the batteries in the controller.
J
Jesus JonesAug 18, 2025
Why Protocol GALILEO STEALTH Drones Dronium III AP will not hover or strafe correctly?
- B
  Bonnie MurphyAug 18, 2025
  If your Protocol Drones Dronium III AP won't hover or strafe correctly, there are a few potential causes. First, the aircraft may not have been on level ground during synchronization. Try re-synchronizing the aircraft and controller. Also, the trim settings could be incorrect. Recalibrate the Altitude Sensor, reset the trim buttons on the controller, and re-trim the flight controls.
A
Angela SchwartzAug 28, 2025
How to fix intermittent control response in Protocol GALILEO STEALTH Drones?
- N
  Nicole PaceAug 28, 2025
  If your Protocol Drones' response to control inputs is intermittent or erratic, the controller battery power may be nearly depleted. Replacing the batteries in the controller should resolve this issue.